If the gun adapter is too short to reach bottom of the DIN Threads and air leaks this washer can be inserted into the adapter so the o-ring makes contact with the washer creating a good seal. Once inserted the washer will make contact with the o-ring preventing air from leaking.
You should only need one but you can stack them to fill a larger gap if needed.
To remove you can use a small L shaped allen wrench or a curved pick to pull it out.
- Special High Strength Washer for DIN 200/300 Bar (PCP & Scuba) Air Tank Valve.
- 200 / 300 Bar cylinder valve adapter / connector sealing washer.
- Approximately 21mm outside diameter with 2mm thickness.
A DIN washer for PCP (Pre-Charged Pneumatic) airguns is a critical, high-pressure sealing component, typically a nylon or bonded (Dowty) washer used on DIN 200/300 bar scuba tank valves and adapters. These washers ensure an airtight connection when filling PCP rifles, preventing air loss at pressures up to 300 bar (approx. 4350 PSI)
Key Details regarding DIN Washer for PCP:
- Purpose: Sealing the connection between a scuba cylinder DIN valve and a PCP fill adapter.
- Material: Polyether Ether Ketone – A high-performance plastic that is particularly suitable for aerospace applications because of its high strength, temperature resistance and low weight making it an ideal material for seals and valve seats.
- Compatibility: Designed for DIN PCP fittings (200/300 bar).
- Type: flat disc
- Maintenance: These are wear items; they should be checked for damage to prevent leaks.
